Description 32+36pin Harley FFJ107: ----------------------------------- Hardware: ----------------------------------------------------- Size : 95mm X 110mm 4 layer PCB CPU : Hitachi H8s2639 20MHz 32bit CPU RAM : Internal 16kbyte. EEPROM : External 16kbyte. Flash : 256kbyte internal for 32bit program. A/D Channels : 12pcs @10bits. D/A Channels : 2pcs. Input/output: ------------- CAN1 Bus : CPU Internal with External driver and Common mode trafo. CAN2 Bus : CPU Internal with External driver and Common mode trafo. PC interface : 6pin FTDI cable connector. EOBD Diagnose : K-line ISO9141, K-line ISO14230 and CAN ISO15765 J1850 : Yes, VPWM. Inputs: -------- Temperature Inputs: 4*Standard Bosch 2kohm@20deg NTC, -30-->120deg range Speeder/Trottle : 4 pcs 0-5V MAP and Others : 0-5V Airmass Meter : 0-5V or frequency input. Lambda/Wideband : 1*Bosch LSU4.2 and/or 2*narrowband Crank Shaft Sensor: 1*Inductive or 1*Hall. Intake CAM Sensor : 1*Inductive or 1*Hall. Speed Sensor : Hall sensor for drive wheels. Outputs: --------- Injectors : 4 pcs minimum 8 Ohm injector outputs Ignitions : 8 pcs +/-20mA / 5V for external ignition drivers. Idle/EGAS : EGAS H-Bridge 15A 300Hz, 1200Hz or 2400Hz RPM output : 0/12V. Reference : 2 pcs. 5.0V Relay outputs : 1A Low side drive. PWM outputs : 3A Low side drive for Wastegate, CAMs and many others Software (LIB351): ------------------- Remap-able A/D in : Most channels can be assigned different usage. Remap-able Outputs: Most PWM and relay outputs can be moved. Userdefined Regs : Yes, Used defined Regulators, Algorithms and 2D/3D Tables. Longterm Lambda : Yes, 2 banks with EEProm storage between starts. Shortterm Lambda : Yes, 2 banks. Trigger Systems : Many different. Ignition Trimmer : Yes, assymmetric engines supported. CAN Bus : Many protocols embedded in code for Plug-Play ECU's. CAN Datalogger : Yes. Secondary Air Ctrl: Yes. Idle Regulation : Yes. EGAS : Yes, Controlable by speeder, speed, AC and others. Injection Timing : Yes, Angle Variable start timing. Injection Trim : Yes, Bank1/Bank2, RPM, and load +/- or pct adjustable. 2-spark ignition : Yes, Below defined RPM, possible to make double sparks. Rollerstand : Yes, build in rollerstand software (Optima2000).